এইচ-বন্ড প্লেক্স প্রোটেক্টর এবং এনহ্যান্সার কিট

The H-Bond Protector line it is designed to protect hair, but if not used in sufficient quantity, it will not have the desired effect. Find out how much of the product you should use to keep hair looking healthy.

HOW TO USE ONE:

H-Bond Protector (P1) next to the Bleaching Powder:

1. Use the standard measure of 30g bleaching powder + 60 ml of hydrogen peroxide + 7,50ml (full meter) of Protector (P1).

Mix well and start the bleaching process according to the chosen technique.

After the discoloration process, rinse hair and scalp thoroughly. Do not use shampoo. Remove excess water with a towel.

To complete the procedure, use the H-Bond Protector Enhancer (P2), evenly distributed over the entire length of the wires. Leave on for 10 to 20 minutes.

Rinse well. Wash and condition with shampoo and conditioner Honma Tokyo of your preference.

HOW TO USE 2:

Spraying H-Bond Protector (P1) 

Divide the hair into 4 parts and apply 2 to 3 sprays wick to lock of the H-Bond Protector (P1) from the middle to the ends.

Align the strands with a fine comb and wait 10 minutes.

After the pause time, without rinsing the hair, start the bleaching process according to the chosen technique.

After the discoloration process, rinse hair and scalp thoroughly. Do not use shampoo. Remove excess water with a towel.

To complete the procedure, use the H-Bond Protector Enhancer (P2), evenly distributed over the entire length of the wires. Leave on for 10 to 20 minutes.